PAGE 12 of 24 VR4K (4+1) SERIES TECHNICAL MANUAL VER1.1
5418 VIDEO SETUP & PROGRAMMING
3 Way dip-switch
1 2 3 Video Mode
ON OFF ON Coax video signal
OFF ON ON Balanced video signal
Switch 3 = Video end of line resistor
To enter programming mode to carryout the following settings, press the two following buttons at the same
time (left button of the volume control and the right button of the colour intensity control) (far left button and
far right button together). When the programming mode is entered LED 1 (The LED next to the ●● button)
starts flashing. This will automatically reset after 20 seconds of idle time.
Door opening time (Factory preset 4 seconds)
After entering the programming mode press and hold the
button, LED 1 will stop flashing and the door
open LED will start to flash for the number of seconds required (i.e. 5 flashes = 5 seconds) release the
button once the required value is reached. LED 1 will start flashing to signal that other programming
operations can be performed.
Privacy duration time (Factory preset 1 hour)
When in the programming mode press and hold the
button, LED 1 will stop flashing and the privacy LED
will start to flash and show the time (each flash =15 minutes i.e. 6 flashes = 1.5 hour) once the time has been
reached release the
button. LED 1 will start flashing to signal that other programming operations can be
performed.
Number of rings (Factory preset 8 rings)
When in the programming mode press and hold the
button, LED 1 will stop flashing and the speak LED
will start to flash showing the number of rings (each flash = 1 ring i.e. 6 flashes = 6 rings) once the value of
rings has been reached release the
button. LED 1 will start flashing to signal that other programming
operations can be performed.
5412 VIDEO SETUP & PROGRAMMING
4 Way dip-switch
1 2 3 4 Video Mode
ON ON OFF ON Coax video signal
ON ON ON OFF Balanced video signal
Switches 1 & 2 = Video end of line
3 Way dip-switch
1 S1 ON = N/O Switch between term. 18 & GND OFF = Camera recall
2 S2 ON = N/O Switch between term. 19 & GND OFF = Camera recall
3 ●● ON = N/O Switch between term. 20 & GND OFF = Camera recall
Melodies Programming (factory preset melody 1)
• Press and hold one of the two melody buttons “
”(for approx 10 seconds) until the unit plays the
current stored melody and emits a beep.
• Press the melody button again (left or right) to listen to the available melodies (maximum 9).
• When the chosen melody has been reached, do not press any buttons wait 3 seconds for the exit
beep. The new melody is now stored.
Number of Rings Programming (factory preset = 6 rings)
• Press and hold the “
” button (for approx 10 seconds) until the unit emits a beep.
• Press the “
” button as many times as the number of rings required (i.e. 6 presses = 6 rings with a
maximum of 9 rings)
• Once the number of rings required has been reached, wait 3 seconds for the exit beep. The new
value is now stored.
Privacy duration programming (factory preset = without time out)
• Press and hold the “
” button (for approx 10 seconds) until the unit emits a beep.
(20 pagine)
(32 pagine)
(72 pagine)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commenti su questo manuale